Using The Charge Control Software "Charge Master; Firmware Update - Skyrc Q200 Instruction Manual

Using The Charge Control Software "Charge Master"

The free "Charge Master" software gives you unparalleled ability to operate the charger
through the computer. You can monitor pack voltage, cell voltage and other data during
the charging, view charge data in real-time graphs. And you can start and control
charging and update the firmware from "Charge Master".
In order to connect the charger to the computer and use the "Charge Master", you are
required to use a USB cable which is not included in this package. The cable must be
terminated on one end with "A" plug and the opposite end with "micro-B" plug which
directly connects to the charger.
You can control, monitor and operate the charger via computer.
The "Charge Master" can be downloaded from www.skyrc.com.

Firmware Update

Follow the instructions below to update the firmware for Q200.
1. Download the firmware (File Name: Q200_Update_VX.XX.exe) from www.skyrc.com.
2. Power the charger and Press START button once.
3. Connect the charger to a computer with a USB cable.
4. Launch Q200_Update_VX.XX
5. Click on the "Update", the firmware update will start automatically. Do not disconnect
the charger from the computer during firmware update.
6. The firmware update will take around 2 minutes.
Q200
Q200 Firmware Update V1.05
Charger is detected
file length: 186368
Q200 Firmware Update V1.05
Charger is detected
file length: 186368
Update
Update
Progressing: 53
31 ·