Skyrc Q200 Instruction Manual page 25

Pb Charge
1.5A 12.0V(6P)
P-6 1.5A 13.56V
CHG 002:22 00106
Pb Discharge Mode:
After selecting the correct battery type, use the INC or DEC buttons to change it to the
"DISCHARGE" mode.
Press the START button and the amp rate value will begin flashing. Use the INC or DEC
buttons to adjust the value to the desired discharge rate. Follow the instructions provided
with your battery when setting the amp rate.
Pb Discharge
1.5A 12.0V(6P)
P-6 1.0A 13.56V
DCH 005:10 00964
Additional Pb Process Information:
During the Pb battery charging/discharging process the Q200 can display a variety of
information. Using the INC or DEC buttons you can also view the following information:
Capacity Cut-Off
ON 5000mAh
Temp Cut-off
50 C
In Power Voltage
12.56V
Q200
Pb Lead-Acid Battery Program
Press the START button again and the nominal battery pack
voltage will begin flashing. Use the INC or DEC button to set the
voltage and the number of cells.
Press and hold the START button for 3 seconds to start
charging.
Once charging has commenced, the charger will display the
following real-time information: battery type, charging current,
battery voltage, charging time and charged capacity.
When charging is complete, the screen will read "FINISHED"
and the charger will emit a ringing sound.
Press the START button again and the nominal battery pack
voltage will begin flashing. Use the INC or DEC buttons to set
the voltage and the number of cells.
Press and hold the START button and discharging will begin.
Once discharging has commenced, the charger will display the
following real-time information: battery type, discharging current,
battery voltage, discharging time and discharged capacity.
When discharging is complete, the screen will read "FINISHED"
and the charger will emit a ringing sound.
Capacity cut-
off setting
Temperature
cut-off
Input voltage
Safety Time
ON 200min
Ext. Temp ----
Int. Temp 37 C
Safety timer
setting
External*/ internal
temperature
23 ·