Changing The Data - Panasonic AFPE224300 User Manual

6.2.2 Changing the data

1. Switching to the data change mode
- When the switch "5" is pressed for about 1 second, the "PV" display turns off and then the "SV" blinks.
While the "SV" is blinking, data can be changed.
Note: When the switch "5" is pressed for about 1 second again, the "SV" display turns off and the "PV"
display blinks. While the "PV" is displayed, the device type can be specified.
2. Changing the data
- Pressing the switch "0" to "5" changes the data displayed. The changed data blinks.
- Pressing the switch "1/2/SET" for about 1 second stops blinking. At this point, data change completes.
Notes:
1. Press the operation switch "5" for about one second when the data display is blinking to cancel the
data under change.
The data change can also be cancelled by turning Y38 ON.
(This is available for Ver. 1.1 or higher.)
2. If you try to change the data to the one which is out of the specified range, the data is displayed in
red only when the "1/2/SET" switch is pressed, and blinking does not stop.
3. When the power ON/OFF or RUN/PROG. mode switching is performed, the data under change will be
cancelled.
6-4
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com