I/O Allocation - Panasonic AFPE224300 User Manual

9.2 I/O Allocation

- I/O Allocation of FP-e control unit
Contact Description
X0 External input
X1 External input
X2 External input
X3 External input
X4 External input
X5 External input
X6 External input
X7 External input
X8
Not used.
XF
X10
CH.0 Temperature data (WX1)
X1F
X20
CH.1 Temperature data (WX2)
X2F
X30 Front switch input "0" switch
X31 Front switch input "1" switch
X32 Front switch input "2" switch
X33 Front switch input "3" switch
X34 Front switch input "4" switch
X35 Front switch input "5" switch
X36 Front switch input "1/2/SET" switch
X37 Front switch input "MODE" switch
X38 Front switch input "0" switch
X39 Front switch input "1" switch
X3A Front switch input "2" switch
X3B Front switch input "3" switch
X3C Front switch input "4" switch
X3D Front switch input "5" switch
X3E Front switch input "1/2/SET" switch
X3F Front switch input "MODE" switch
X40 Data setting error (Out of the specified 16-bit)
X41 Determination of N mode 1
X42 Determination of N mode 2
X43 Determination of R mode 1
X44 Determination of R mode 2
X45 Not used.
X46 Not used.
X47 Not used.
X48 Not used.
X49 N mode 1
X4A N mode 2
X4B R mode 1
X4C R mode 2
X4D Not used.
X4E CH. 0 Temperature conversion completion flag
X4F CH. 1 Temperature conversion completion flag
Note 1) To cancel the data change, press the operation switch "5" for 1 second, or switch the mode using the
RUN/PROG. switch.
The data change can also be cancelled by turning Y38 ON. (Ver.1.1 or higher)
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
st
screen data
nd
screen data
st
screen data
nd
screen data
st
screen data is being changed.
nd
screen data is being changed.
st
screen data is being changed.
nd
screen data is being changed.
Note
X0 to X5: Used for thermocouple input type.
X6, X7: Not used. (Thermocouple input type)
Used only for thermocouple input type.
Used only for thermocouple input type.
Available when the mode is set to S or I mode
(Not available when the mode is set to "LOCK.")
Note: X30 to X3F do not turn ON in the 1
ning after the mode is set to RUN.
Available in all modes
(Available even when the mode is set to "LOCK.")
Note: X30 to X3F do not turn ON in the 1
after the mode is set to RUN.
When the data change starts: 0
When the data is determined: 1
When the data is being changed: 1
Date is determined or cancelled: 0
st
scan-
st
scan
Note 1)
9-9