Changing The Unit No. Of Com. Port - Panasonic AFPE224300 User Manual

6.2.3 Changing the unit No. of COM. port

The unit No. specified in the system register can be changed by the front switch (for Ver. 1.2 or
higher).
1. Displaying the unit No.
- Press the switch "4" to display the unit No.
2. Switching to the unit No. change mode
- When the switch "5" is pressed for about 1 second, the "PV" display turns off and then the "SV" blinks.
While the "SV" is blinking, data can be changed.
Note: When the switch "5" is pressed for about 1 second again, the "SV" display turns off and the "PV"
display blinks. While the "PV" is displayed, the device type can be specified.
3. Changing the unit No.
- Pressing the switch "0" and "1" changes the unit No. displayed. The changed No. blinks.
- Pressing the switch "1/2/SET" for about 1 second stops blinking. At this point, data change completes.
Notes:
1. Change the unit No. in PROG. mode.
The unit No. cannot be changed in RUN mode.
2. Press the operation switch "5" for about one second when the unit No. display is blinking to cancel the
unit No. under change.
3. If you try to change the data to the one which is out of the specified range (1 to 99), the changing
process of the unit No. is cancelled by pressing the "1/2/SET" switch.
4. When the power ON/OFF or RUN/PROG. mode switching is performed, the data under change will be
cancelled.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
6-5