Report Mode - Siemens FIREFINDER-XLS Installation, Operation And Maintenance Manual

FIREFINDER-XLS INSTALLATION, OPERATION AND MAINTENANCE MANUAL
REPORT MODE (Reporting Detector Sensitivities)
3-12
OPERATION
A local Command Station can only request access if its node is in network
standalone mode (that is, if it has lost communication with the global node that is in
control).
In Canada, if a network is configured to include multiple Display and Control centres,
it is recommended to configure the network for Single Point of Control. If MNS
support is enabled in Zeus, the system must be configured for Single Point of
Control.
In Canada, ULC S524 requires that each control unit and transponder for Large-Scale
networks (greater than 1000 points, with more than one control panel or transpon-
der) include visual indicators for Stand-alone and Degraded operating modes. This can
be accomplished using LEDs on an LCM module.
Press the Menu button on the PMI/PMI-2/PMI-3 (upper right) and select the Report
option by pressing the key with the lit green LED pointing to the Report label.
Press the More Info/+ button on the PMI/PMI-2/PMI-3 to navigate to the desired loop
or specific device. When More Info is pressed once it displays the FireFinder-XLS node.
• Press the More Info/+ button again to display a list of FireFinder-XLS
modules; use the up and down buttons to select the desired module.
• Press the More Info/+ button again to display a list of FireFinder-XLS sub-
modules (provided your system has sub-modules installed); use the up and
down buttons to select the desired sub-module.
• Press the More Info/+ button again to display a list
of FireFinder-XLS devices; use the up and down buttons to select the
desired device.
There are four options that can be selected in the Report Mode: Configuration,
Status, Queue and History.
For more details on Reports, refer to the PMI Operation Manual, P/N 315-033874.
| CHAPTER 3