Siemens FIREFINDER-XLS Installation, Operation And Maintenance Manual page 78

CHAPTER 5 |
Alert
FIREFINDER-XLS INSTALLATION, OPERATION AND MAINTENANCE MANUAL
The Alert operation consists of the following functions which are described below:
All Alert and Select Alert.
All Alert
All Alert sends, with a single switch press, the alert tone or message (predetermined
in the system design) to all speaker groups in the local PMI/PMI-2/PMI-3 only.
Selecting All Alert overrides All Convenience Page and All Background Music.
Global All Alert sends the alert tone or message (predetermined in the system
design) to all speaker groups across all PMI/PMI-2/PMI-3 nodes in the system.
To select All Alert, follow the steps listed below.
1. Depress the All Alert switch.
2. The All Alert, Display Alert and all Speaker Group switch LEDs turn on
flashing red.
3. All speaker groups sound the alert tone or message.
4. To end All Alert, depress the All Alert switch again.
5. The alert signal turns off (assuming no automatic alarms exist).
6. The All Alert, Display Alert and all Speaker Group switch LEDs turn off.
Select Alert
Select Alert sends the alert tone or message (predetermined in the system design)
to selected local or remote speaker groups in the system. Choosing Select Alert
overrides Select Convenience Page and Select Background Music.
To select Select Alert, follow the steps listed below.
1. Depress the Select Alert switch, the LED flashes red.
2. Depress the desired individual Speaker Group switches.
3. The selected Speaker Group and Display Alert switch LEDs flash red.
4. If no Speaker Group switches are pressed for 120 seconds, the system
automatically returns to normal.
5. The selected speaker groups sound the alert tone or message.
6. To end Select Alert, first depress the selected Speaker Group switches,
then Select Alert.
7 . The alert signal turns off (assuming no automatic alarms exist).
8. The Select Alert, Display Alert and all Speaker Group switch LEDs turn off.
5-11
GLOBAL VOICE