Installation; Introduction; Installation Guidelines - Siemens FIREFINDER-XLS Installation, Operation And Maintenance Manual

2

INTRODUCTION

INSTALLATION GUIDELINES

This section provides general instructions for mounting and wiring the FireFinder-XLS
Control Panel.
Read this section before installing the equipment to ensure proper installation. If you
are not familiar with the FireFinder-XLS System, also read the first section of the
manual. Be sure to ask Siemens Industry, Inc. Technical Support or an authorized
Representative if you have any questions.
Install and use the FireFinder-XLS System in accordance with the appropriate Local,
NFPA and NEC Code requirements.
Alw Alwa a a a a y y y y y s remo Alw Alw Alw s remo s remo s remo s remove power ve power (battery and AC) and wait at least 10 seconds to allow the ve power ve power ve power
supply voltages to decay before installing or removing any module, cable or wiring.
Follow Steps 1 through 21 for installation. Each step is thoroughly explained in the
referenced installation instructions. A description of all compatible FireFinder-XLS
system modules and devices can be found in the FireFinder-XLS Installation Instruc-
tions Index, P/N 315-034242.
1. Install the desired enclosure; CAB1, CAB2 or CAB3. Refer to the CAB
Enclosure Components table on page 2-2 to select the appropriate installation
instructions. Refer also to Figure 2-1 on page 2-3 for information on CAB
rows and module placement.
When converting an MXL panel to an XLS panel, refer to the FireFinder-XLS
Adapter Kits table on page 2-3.
2. Install the HTSW-1 Tamper Switch where required (Refer to the HTSW-1
Installation Instructions, P/N 315-033350).
3. Pull the field wiring into the backbox and dress it to approximately where it will go.
4. Install the PMI, PMI-2, or PMI-3 on the inner door (Refer to the PMI Installa-
tion Instructions, P/N 315-033070, the PMI-2 Installation Instructions, P/N
315-050636, or the PMI-3 Installation Instructions, Document ID
A6V10446194, as applicable).
5. Install the CC-5/CC-2 on the studs in the backbox or an optional CAB-MP
mounting plate (Refer to the CC-5/CC-2 Installation Instructions, P/N 315-
033035). Do not install the card guides in the CC-5/CC-2 at this time. The
CC-5/CC-2 may be installed on the optional mounting plate outside of the
enclosure or with the plate installed in the enclosure (Refer to the CC-5/CC-
2 Installation Instructions, P/N 315-033035). If the Mounting Plate is located
inside the enclosure you will have to gain access to it by opening the
enclosure Inner and Outer doors. If the CC-5/CC-2 is installed on the
optional mounting plate outside of the enclosure, place it in front of you so
that the word "TOP" is at the top and away from you.
2-1

INSTALLATION