Power, Hdd Led Indicator; Power Button; Rest Tact Switch; Ethernet Ports - Vecow ABP-2000 User Manual

2.2.1 Power, HDD LED Indicator

Yellow-HDD LED: A hard disk / CFast LED. If the LED
is on, it indicates that the system's storage is functional.
If it is off, it indicates that the system's storage is not
functional. If it is flashing, it indicates data access
activities.
Green-Power LED: If the LED is solid green, it indicates
that the system is powered on.

2.2.2 Power Button

The power button is a non-latched switch with dual color
LED (Blue/Orange) for indication S0, S3 and S5 status.
Power button dual-color LED indicator:
Status
S0
S3, S5
To turn on the ABP-2000 series, press the power button
and the blue LED is lighted up.To turn off the ABP-2000
series, you can either issue a shutdown command in
OS, or just simply press the power button.
In case of system halts, you can press and hold the
power button for 4 seconds to compulsorily shut down
the system.Please note that a 4 seconds interval is kept
by the system between two on/off operations (i.e. once
turning off the system, you shall wait for 4 seconds to
initiate another power-on operation).
©Vecow ABP-2000 Series Advanced Box PC User Manual
LED Display System Situation
Solid Blue System working
Solid Orange Suspend to RAM, System off
with standby power
Getting to Know Your ABP-2000
10

2.2.3 Rest Tact Switch

It is a hardware reset switch. Use this switch to reset
the system without turning off the power. Momentarily
pressing the switch will activate a reset.

2.2.4 Ethernet Ports

The 10/100/1000 Mbps Ethernet LAN ports 1 and 2 use
8-pin RJ-45 connectors. LNA1 and LAN2 are equipped
with Intel® 82574L controllers.
Using suitable RJ-45 cable, you can connect ABP-
2000 series system to a computer, or to any other
piece of equipment that has an Ethernet connection,
for example, a hub or a switch. Moreover, both of
them have Wake-on-LAN and pre-boot Execution
Environment capabilities.
The following diagram shows the pinouts for LAN1 and
LAN2 ports.
Pin No. 10 / 100 Mbps
1 E_TX+
2 E_TX-
3 E_RX+
4 ----
5 -----
6 E_RX-
7 -----
8 ------
The Ethernet ports use standard RJ-45 jack connectors
with LED indicators on the front side to show Active/
Link status and Speed status. The LED indicators on
Getting to Know Your ABP-2000
1000 Mbps
MDI0_P
MDI0_N
MDI1_P
MDI2_P
MDI2_N
MDI1_N
MDI3_P
MDI3_N
11