3
Site Preparation
Site Requirements for the G4240A Chip Cube
Site Requirements for the G4240A Chip Cube
Power Considerations
Shock hazard or damage to your G4240A Chip Cube may result if the instrument is
WA R N I N G
connected to line voltage higher than specified.
To disconnect the instrument from line, unplug the power cord. The power supply
WA R N I N G
still uses some power, even if the power switch on the front panel is turned off.
Never use cables other than the ones supplied by Agilent Technologies to ensure
WA R N I N G
proper functionality and compliance with safety or EMC regulations.
Bench Space
32
The G4240A Chip Cube power supply has wide ranging
capabilities and accepts any line voltage in the range of
100–240 V with a line frequency of 50–60 Hz see also Table 3
on page 34 for more details). Consequently, there is no voltage
selector in the rear of the instrument.
Three power outlet are required for:
•
Chip Cube
•
external power supply for Chip Cube Interface Assembly
•
Video monitor
The G4240A Chip Cube requires sufficient laboratory bench
space. For a complete HPLC-Chip MS system for the bench
space needed refer to
benches with appropriate weight rating should be used.
Table 3
on page 34. Only desks and
HPLC-Chip Cube Interface User's Guide