Basic Configuration; Pppoe - UNIVIEW NVR201-04E User Manual

Basic Configuration

1. Click Menu > System > Network > Basic.
2. Set the network parameters as needed.
The NVR provides three working modes:
Multi-address mode: The two NICs work independently and can be configured separately. Either

NIC can be chosen as the default route, and data will be forwarded through this NIC when the
NVR connects to the extranet.
Load balance mode: The two NICs are bound to the same IP address and work together to share

network traffic.
Net fault-tolerance mode: The two NICs are bound to the same IP address. In cases where one

NIC fails, the other takes over service seamlessly from the faulty one to ensure network
connectivity.
3. Click Apply to complete the configuration.
NOTE!
If a DHCP server is available on the network, you can enable DHCP so the NVR automatically obtains

an IP address from the DHCP server.
If your NVR has a PoE port or a switching port, you can configure an internal NIC IPv4 address.


PPPoE

The NVR allows access through Point-to-Point over Ethernet (PPPoE).
1. Click Menu > System > Network > PPPoE.
52