Initial Configuration; Preparation; Startup Wizard - UNIVIEW NVR201-04E User Manual

2

Initial Configuration

Preparation

Make sure that at least one monitor is correctly connected to the VGA or HDMI interface on the

rear panel of the NVR.
Verify that the hard disk(s) are correctly installed. For detailed steps to install a hard disk, please

refer to the quick guide shipped with your NVR.

Startup Wizard

The startup wizard can guide you to complete the most basic configuration.
1. Choose a language for the system and then click OK.
2. Enable or disable the startup wizard as needed and then click Next.
NOTE!
When disabled, the startup wizard does not show up as the NVR starts. You may enable or disable
the startup wizard later under Menu > System > Basic.
3. Enable or disable the Auto-Add IP Camera function as needed and then click Next.
5