UNIVIEW NVR201-04E User Manual page 13

6. Set the IP address, subnet mask and default gateway for your NVR. Use the default settings for
other parameters unless a modification is necessary. Click Next when you are ready.
NOTE!
For an NVR with multiple Network Interface Cards (NICs), you can configure the NICs and select one

as the default route.
An internal IPv4 address can be configured if your NVR has PoE ports or switching ports.

The Camera window will not be displayed if the Auto-Add IP Camera function has been enabled in

step 2.
7. Click Search. The discovered IP devices are listed. Select the desired IP device and then click Add.
After the IP device is added successfully, click Next.
7