Conair TrueBlend TB45-4 User Manual page 65

TrueBlend™
To activate the Batch Mode, press the
off button in the top panel position.
The "gray" button will change to "green"
indicating this mode is now activated.
Next enter the target weight in the
next panel position.
The units will be either "lbs" or "kg". If you
need to change from one to the other,
please refer to section 7.15 System
Setup.
To start the blender operating, return
to the Blender Status screen and
press the "On/Off" button.
The blender will then begin to weigh the
target value. You can return to the Batch
Mode screen and monitor process as this
is being done.
The actual weighed value will be at least the target value you have entered plus
up to one additional weighed batch of the blender model you are using. The
reason being that the blender can't stop in the middle of an individual batch, but
NOTE
the actual total weight will be indicated and all the ingredients will be included in
correct proportions.
The next panel position on this screen will
display the "Current Weight" which could
be a portion of the target value if one is
viewing during operation or the target
weight if the blender has finished.
The last panel on this screen displays the
status of the batch mode which can be; ---
(if the batch Mode is not activated),
"Running" (if in the process of making a
Batch), "Finished" (if the targeted batch
has been completed) or "Stopped"
(appears after the previous Batch amount
has been reset).
Edition: February 2007
Operation
63