Conair TrueBlend TB45-4 User Manual page 27

T B 2 5 0 - R - 4
T r u e Bl e nd™
TPBS035-0207
Side view
C
1
MODELS
Performance characteristics
Batch size lb {g}
Maximum throughput rate lb/hr {kg/hr}*
Bin capacity - main ingredient ft
Bin capacity - minor ingredient ft
Maximum number of materials
Number of vertical discharge valves
Number/(size) of major bin valves
Number/(size) of minor bin valves
Dimensions inches {mm}
A - Height above mounting plate †
B - Width
C - Depth
D - Control height
E - Control width
F - Control depth
Weight lbs {kg}
Installed
Shipping
Voltage total amps
115V/1 phase/60 hz
230V/1 phase/50 hz
Compressed air requirements
Discharge valves
Maximum loader sizes
15 inch loaders - number of loaders -
8 inch loaders- number of loaders -
Edition: February 2007
Front view
B
4
A
Drain chute
Purchase the
material drain chute
that readily installs to the
chassis opening of the
blender for fast and
simple cleanout.
TB250R-4
5.5 {2500}
800 {363}
3 {liter} 1.6 {45.3}
3 {liter} 0.3 {8}
4
4
2 - (60 mm)
2 - (20 mm)
(removable)
57.50 {1461}
36.50 {926}
38.88 {988}
8.25 {209.6}
9.25 {235.0}
4.75 {120.6}
280
400
6.3
3.2
90 psi @ 0.2 ft 3 /min
{6 bars @ 0.09 liters/sec};
1/4 in. NPT fitting
2
2
3
optional
MOUNTING INTERFACE
Dimensions
shown in
inches and {mm}.
3-5/32
diameter
{80}
2-1/16
{53}
Mounting bolt hole size (8 holes) 9/16 inch {14.0 mm}.
Predrilled 8 x 8 and 12 X 12 mounting pattern as standard.
SPECIFICATION NOTES
*
Maximum throughput rates are based on 35 lb/ft
and using all standard valve sizes. Use of reducer inserts will lower
the rate shown.
†
The optional flow control valve will mount inside the chassis in the
space of the manual slide valve. Conair recommends using the
optional flow control valve when mounting the blender on a stand,
surge bin or hopper.
‡ TB250R-4 hopper position two is supplied with a 12-8 adapter with
an eight inch cover plate as standard. Position three and four are
supplied with hand-fill lids.
Specifications may change without notice consult with a Conair repre-
sentative for the most current information.
T e c h n i c a l S p e c i f i c a t i o n s
Top view
4 position
Position 1
‡Position 4
‡Position 3
Control
F
Mixing chamber access door -
this side of the interface.
16-5/32 {410}
12 {305}
8 {203}
8-1/16
{205}
4-1/16
{103}
3
pelletized material
‡Position 2
D
E
25