Loading Factory Defaults; Enrolling Modules And Keypads; Quick Start Installation - GE Interlogix NX-8 Installation And Startup

5.

LOADING FACTORY DEFAULTS

Follow procedures on page 11 to enter the Program Mode.
6.

ENROLLING MODULES AND KEYPADS

For supervision purposes, the NetworX control panel has the ability to automatically find and store in its memory the
presence of all keypads, zone expanders, wireless receivers, and any other module connected to the data terminal. This
allows these modules to be supervised by the control panel. NOTE: All modules should be connected and set to unique
addresses prior to enrolling modules. To enroll the modules, enter the Program Mode of the NetworX control panel.
When the Program Mode is exited, the control will enroll the devices. The enrolling process takes about 12 seconds,
during which time the "Service Required" will be displayed. Once a module is enrolled, if it is not detected by the
control, the "Service Required@ will be displayed.
Please refer to the NX-148ECF installation manual for complete instructions on programming the keypads.
7.

QUICK START INSTALLATION

For most routine installations, the "Quick Start" option will allow for enabling a majority of the options available with the
NX-8-CF, when communicating in Contact ID or SIA formats and without partitioning. The "Quick Start" locations can
be identified with
NX-8 Commercial Fire
Technical Manuals Online! - http://www.tech-man.com
Action
910#
Keypad will beep 3 times (loading is in progress). The loading
takes about 6 seconds.
Result
13