Exiting A Location; Exiting The Program Mode - GE Interlogix NX-8 Installation And Startup

BINARY DATA
2.
The top line of the display will show the current location number on the left and the segment number on the
right. The data will be displayed on the bottom line with the numbers 1-8 in the first 8 characters. If the number
appears, this binary switch is on. If a minus sign (-) appears where the number should be, this switch is off.
Toggle numbers on or off using the corresponding number digit (1 to toggle 1; 8 to toggle 8). When the numbers
are in the desired state, enter
for this segment will now be displayed. Continue this process until the last segment is programmed. When the
last segment is reached, the keypad will prompt for the next location. If you wish to exit this location before the
last segment is reached, press #. This keypress will not save the changes made to current segment, but will exit
the location. "Shortcut Keys" shown in Numerical Data can also be used for Binary Data.
CHARACTER DATA
3.
Character Data is used to enter LCD text when programming. (Refer to the NX-148ECF instruction manual for
custom messages
data type. This information is programmed using the bottom line of the display as a text editor. Once a character
location has been entered, the current data will be displayed on the bottom line. As is always the case, the top
line will display the current location and segment number. The five (5) function keys, as well as the up and down
arrow to the right of the display, are now used to edit the message prior to saving it back to the location storage.
An underscore (_) in the display indicates the current cursor location.
Shortcut keys:

EXITING A LOCATION

EXITING THE PROGRAM MODE

12
Technical Manuals Online! - http://www.tech-man.com
. The data will be entered and the segment will be incremented by 1. The data
feature.) Custom zone descriptions and messages are stored character or ASCII
CANCEL
or
STAY
CHIME
EXIT
BYPASS
#
Action
Action
EXIT
EXIT
Saves character or word; moves cursor to right
Moves cursor to left.
Scrolls through available characters.
(In Library Mode) Scrolls through available words.
Tip: Refer to the NX-148ECF instructions for more details.
Inserts blank space.
Deletes characters.
Accesses the Library
Tip: Refer to the NX-148ECF instructions for more details.
Makes the character "flash".
(In Library Mode) Makes the entire word "flash".
Exits the edit mode.
Saves the data and exits that location.
Tip: The must be pressed or the data will not be saved.
To exit before the last segment, press #.
You are now ready to program another location.
Exits this program level. Advances to "Select a Module".
Exits the programming mode entirely.
Result
Result
NX-8 Commercial Fire