ABB ACS880-107 Hardware Manual page 53

Notes:
The wire size accepted by all screw terminals (for both stranded and solid wire) is
2
0.5 ... 2.5 mm (24...12 AWG). The torque is 0.5 N·m (5 lbf·in).
1)
Current [0(4)...20 mA, R
selected by jumper J2. Change of setting requires reboot of control unit.
2)
Current [0(4)...20 mA, R
selected by jumper J1. Change of setting requires reboot of control unit.
3)
See section Drive-to-drive link (XD2D)
4)
See chapter The Safe torque off function
5)
Constant speed 1 is defined by parameter 22.26.
6)
0 = Acceleration/deceleration ramps defined by parameters 23.12/23.13 in use.
1 = Acceleration/deceleration ramps defined by parameters 23.14/23.15 in use.
7)
Jumper/switch J6. Determines whether DICOM is separated from DIOGND (ie. common
reference for digital inputs floats; in practice, selects whether the digital inputs are used in
current sinking or sourcing mode). See also
8)
See section DIIL input
9)
Total load capacity of these outputs is 4.8 W (200 mA at 24 V) minus the power taken by
DIO1 and DIO2.
= 100 ohm] or voltage [0(2)...10 V, R
in
= 100 ohm] or voltage [0(2)...10 V, R
in
(page 57).
(page 157).
Ground isolation diagram (ZCU)
(page 57).
The inverter control unit 53
> 200 kohm] input
in
> 200 kohm] input
in
(page 61).