Expansion Line Cards; Rear Panel Components - Check Point 4200 Getting Started Manual

• Subnet netmask
• Default gateway
To configure the management IP address using the LCD panel:
1. Press Enter
The panel shows Select > Network.
2. Press Enter
The panel shows Network > DHCP.
3. Press Down
The panel shows Network > Set Mgmt IP.
4. Press Enter
The panel shows the management interface IP address.
5. Configure the management interface IP address.
a) Press Up or Down,
b) Press Right or Enter,
c) When the panel shows the correct IP address, move the cursor to the last digit and
press Enter
The panel shows Network > Set Mgmt IP.
6. Do steps 3 - 5 again for the subnet netmask and the default gateway IP address.
7. Press Esc

Expansion Line Cards

There are different expansion line cards that you can use with the appliance. For more about
the expansion line cards, see the 4000 Appliances home page
(http://supportcontent.checkpoint.com/solutions?id=sk68681).

Rear Panel Components

This section describes components located on the rear panel of the appliance.
Important - Only use the appliance when the Security Acceleration Module or the
placeholder tray is in the upper slot to make sure the appliance is cooled correctly.
.
.
.
.
or , to change the digit.
or
.
until the panel shows the appliance logo.
Check Point 4000 Appliances Getting Started Guide
, to move to the next digit.
4000 Appliances Hardware
| 33