Restoring Factory Defaults; Restoring Using The Webui; Gaia - Check Point 4200 Getting Started Manual

Chapter 5

Restoring Factory Defaults

In This Section:

Restoring Using the WebUI

Restoring Using the Console Boot Menu
Restoring Using the LCD Panel
If necessary, restore the appliance to its factory default settings or select a new image.
Important - If you restore factory defaults or select a new image, all information
on the appliance is deleted.
Restoring Using the WebUI
Use the WebUI of the applicable operating system to restore the appliance to the factory
default settings. You can select one of the software images that are available on the appliance.

Gaia

Use the Gaia WebUI to restore the default factory settings.
To restore a Gaia appliance with the WebUI:
1. Open an Internet browser to the management IP address,
https://<appliance_ip_address>
2. Log in to the WebUI of the appliance using the administrator username and password.
3. In the WebUI, click Maintenance > Factory Defaults.
The Factory Defaults window opens.
4. Select the image version that you are restoring.
5. Click Apply.
............................................................................
........................................................
......................................................................
Check Point 4000 Appliances Getting Started Guide
35
36
37
| 35