Check Point 4200 Getting Started Manual page 6

Safety, Environmental, and Electronic Emissions Notices
• Disconnect the system board power supply from its power source before you connect or
disconnect cables or install or remove any system board components. Failure to do this can
result in personnel injury or equipment damage.
• Avoid short-circuiting the lithium battery; this can cause it to superheat and cause burns if
touched.
• Do not operate the processor without a thermal solution. Damage to the processor can
occur in seconds.
• Class 1 laser product warning - A totally enclosed laser system containing a class 1 laser.
Rack Mount Instructions
The following or similar rack-mount instructions are included with the installation instructions:
1. Elevated Operating Ambient - If installed in a closed or multi-unit rack assembly, the
operating ambient temperature of the rack environment may be greater than room ambient.
Therefore, consideration should be given to installing the equipment in an environment
compatible with the maximum ambient temperature specified by the manufacturer.
2. Reduced Air Flow - Installation of the equipment in a rack should be such that the amount
of air flow required for safe operation of the equipment is not compromised.
3. Mechanical Loading - Mounting of the equipment in the rack should be such that a
hazardous condition is not achieved due to uneven mechanical loading.
4. Circuit Overloading - Consideration should be given to the connection of the equipment to
the supply circuit and the effect that overloading of the circuits might have on over current
protection and supply wiring. Appropriate consideration of equipment nameplate ratings
should be used when addressing this concern.
5. Reliable Earthing - Reliable earthing of rack-mounted equipment should be maintained.
Particular attention should be given to supply connections other than direct connections to
the branch circuit (e.g. use of power strips).
For California:
Perchlorate Material - special handling may apply. See
http://www.dtsc.ca.gov/hazardouswaste/perchlorate
The foregoing notice is provided in accordance with California Code of Regulations Title 22,
Division 4.5, Chapter 33. Best Management Practices for Perchlorate Materials. This product,
part, or both may include a lithium manganese dioxide battery which contains a perchlorate
substance.
Proposition 65 Chemical
Chemicals identified by the State of California, pursuant to the requirements of the California
Safe Drinking Water and Toxic Enforcement Act of 1986, California Health & Safety Code s.
25249.5, et seq. ("Proposition 65"), that is "known to the State to cause cancer or reproductive
toxicity" (see http://www.calepa.ca.gov)
6 | Check Point 4000 Appliances Getting Started Guide