Vega VEGASCAN 693 Operating Instructions Manual page 23

Diagnostics
Service
Service - Reset
Service - Change sensor ad-
dress
VEGASCAN 693 - 15-channel HART signal conditioning instrument
Setup with the integrated indicating and adjustment unit
▼
Percent
à
Enter the requested parameter via the appropriate keys
and save your settings with [OK].
If the instrument dispays a failure message you can open via
the menu item "Diagnosis - Device status - Add. information".
Sensor status
E007
Sensor type not compatible
The service menu contains the following settings:
Simulation of the measured value
l
Reset
l
Set display language
l
PIN to block the menu
l
Change HART sensor address
l
à
Enter the requested parameter via the appropriate keys
and save your settings with [OK].
There are two reset modes:
Reset to default: despite of a few exceptions, all settings
l
will be reset to default. Exceptions are: IP-addr., subnet
mask, time, language.
Reset to measurement loop: Only user-specific settings of
l
an individual measurement loop are reset. These are e.g.
adjustment, linearisation, scaling, damping, parameters of
the outputs.
Reset
Factory setting
Reset now?
Under this menu item you can assign and modify the HART
addresses of the connected sensors.
23