Vega VEGASCAN 693 Operating Instructions Manual page 18

Setup with the integrated indicating and adjustment unit
Switch-on phase
Measured value indication/
Main menu
Device settings - Device-TAG
18
After being switched on, VEGASCAN 693 first of all carries out
a short self-check. The following steps are carried out:
Internal check of the electronics
l
indication of the instrument type, firmware version as well
l
as the instrument TAG (instrument name)
the output signals jump briefly to the set fault current
l
Then the current measured values will be displayed and
outputted.
The measured value indication displays three measured
values each in one common window. The digital display value,
the measurement loop designation (meas. loop TAG) and the
unit are shown. By pushing the [>] key, you can move to the
next three measured values.
32.6
%
■
TAG-No. 1
à
By pushing [OK] you move from the measured value
indication to the main menu.
▶
Device settings
Meas. loops
Display
Diagnostics
Service
Info
à
Select the menu item "Device settings" with [->] and
confirm with [OK].
You can assign an unambiguous name to VEGASCAN 693 via
the Device-TAG. This function is recommended when several
VEGAMETs are implemented and a good documentation of
larger system is required.
Device-TAG
Device Name
à
Enter the requested values via the appropriate keys and
save your settings with [OK].
VEGASCAN 693 - 15-channel HART signal conditioning instrument