Dielectric Strength - GE C30 Instruction Manual

3 HARDWARE
The dielectric strength of the UR-series module hardware is shown in the following table:
Table 3–1: DIELECTRIC STRENGTH OF UR-SERIES MODULE HARDWARE
MODULE MODULE FUNCTION
TYPE
1 Power supply
1 Power supply
1 Power supply
2 Reserved
3 Reserved
4 Reserved
5 Analog inputs/outputs
6 Digital inputs/outputs
G.703
7
RS422
9 CPU
Filter networks and transient protection clamps are used in the hardware to prevent damage caused by high peak voltage
transients, radio frequency interference (RFI), and electromagnetic interference (EMI). These protective components can
be damaged by application of the ANSI/IEEE C37.90 specified test voltage for a period longer than the specified one min-
ute.
GE Multilin
TERMINALS
FROM
High (+); Low (+); (–)
48 V DC (+) and (–)
Relay terminals
N/A
N/A
N/A
All except 8b
All
All except 2b, 3a, 7b, 8a
All except 6a, 7b, 8a
All
C30 Controller System

3.2.2 DIELECTRIC STRENGTH

DIELECTRIC STRENGTH
(AC)
TO
Chassis 2000 V AC for 1 minute
Chassis 2000 V AC for 1 minute
Chassis 2000 V AC for 1 minute
N/A N/A
N/A N/A
N/A N/A
Chassis < 50 V DC
Chassis 2000 V AC for 1 minute
Chassis 2000 V AC for 1 minute
Chassis < 50 V DC
Chassis 2000 V AC for 1 minute
3.2 WIRING
3
3-11