GE C30 Instruction Manual page 18
Controller system
ur series
Hide thumbs
Also See for C30:
- Instruction manual (488 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (447 pages)
Table of Contents
Advertisement
1.3 ENERVISTA UR SETUP SOFTWARE
8.
Select "Serial" from the Interface drop-down list. This will display a number of interface parameters that must be
entered for proper serial communications.
1
9.
Enter the relay slave address, COM port, baud rate, and parity settings from the
MUNICATIONS
10. Click the Read Order Code button to connect to the C30 device and upload the order code. If an communications
error occurs, ensure that the EnerVista UR Setup serial communications values entered in the previous step corre-
spond to the relay setting values.
11. Click "OK" when the relay order code has been received. The new device will be added to the Site List window (or
Online window) located in the top left corner of the main EnerVista UR Setup window.
The Site Device has now been configured for RS232 communications. Proceed to the Connecting to the C30 section to
begin communications.
c) CONFIGURING ETHERNET COMMUNICATIONS
Before starting, verify that the Ethernet network cable is properly connected to the Ethernet port on the back of the relay. To
setup the relay for Ethernet communications, it will be necessary to define a Site, then add the relay as a Device at that site.
1.
Verify that the latest version of the EnerVista UR Setup software is installed (available from the GE EnerVista CD or
online from http://www.GEmultilin.com). See the Software Installation section for installation details.
2.
Select the "UR" device from the EnerVista Launchpad to start EnerVista UR Setup.
3.
Click the Device Setup button to open the Device Setup window, then click the Add Site button to define a new site.
4.
Enter the desired site name in the "Site Name" field. If desired, a short description of site can also be entered along
with the display order of devices defined for the site. In this example, we will use "Location 2" as the site name. Click
the OK button when complete.
5.
The new site will appear in the upper-left list in the EnerVista UR Setup window. Click the Device Setup button then
select the new site to re-open the Device Setup window.
6.
Click the Add Device button to define the new device.
7.
Enter the desired name in the "Device Name" field and a description (optional) of the site.
1-8
Figure 1–4: CONFIGURING SERIAL COMMUNICATIONS
menu in their respective fields.
SERIAL PORTS
C30 Controller System
1 GETTING STARTED
SETTINGS
PRODUCT SETUP
GE Multilin
COM-
Advertisement
Table of Contents
