GE C30 Instruction Manual page 178
Controller system
ur series
Hide thumbs
Also See for C30:
- Instruction manual (488 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (441 pages)
Table of Contents
Advertisement
5.2 PRODUCT SETUP
5 SETTINGS
To safeguard against the installation of a relay without any entered settings, the unit will not allow signaling of any output
relay until
is set to "Programmed". This setting is defaulted to "Not Programmed" when at the factory. The
RELAY SETTINGS
self-test error message is displayed until the relay is put into the "Programmed" state.
UNIT NOT PROGRAMMED
The
setting allows the user to uniquely identify a relay. This name will appear on generated reports. This name
RELAY NAME
is also used to identify specific devices which are engaged in automatically sending/receiving data over the Ethernet com-
munications channel using the IEC 61850 protocol.
5
5-58
C30 Controller System
GE Multilin
Advertisement
Table of Contents
