GE C30 Instruction Manual page 146

5.2 PRODUCT SETUP
The breaker configuration settings are shown below. Changes to these values will not take effect until the UR is restarted:
PATH: SETTINGS PRODUCT SETUP
XCBR
CONFIGURATION
The
CLEAR XCBR1 OpCnt
XCBR operating counter status attribute (OpCnt) increments with every operation. Frequent breaker operation may result
in very large OpCnt values over time. This setting allows the OpCnt to be reset to "0" for XCBR1.
5
The disconnect switch configuration settings are shown below. Changes to these values will not take effect until the UR is
restarted:
PATH: SETTINGS PRODUCT SETUP
XSWI
CONFIGURATION
The
CLEAR XSWI1 OpCnt
opening and closing, the XSWI operating counter status attribute (OpCnt) increments with every operation. Frequent switch
operation may result in very large OpCnt values over time. This setting allows the OpCnt to be reset to "0" for XSWI1.
Since GSSE/GOOSE messages are multicast Ethernet by specification, they will not usually be forwarded by net-
work routers. However, GOOSE messages may be fowarded by routers if the router has been configured for VLAN
NOTE
functionality.
5-26
COMMUNICATIONS
XCBR1 ST.LOC OPERAND
Off
XCBR2 ST.LOC OPERAND
MESSAGE
Off
XCBR6 ST.LOC OPERAND
MESSAGE
Off
CLEAR XCBR1 OpCnt:
MESSAGE
No
CLEAR XCBR2 OpCnt:
MESSAGE
No
CLEAR XCBR6 OpCnt:
MESSAGE
No
setting represents the breaker operating counter. As breakers operate by opening and closing, the
COMMUNICATIONS
XSWI1 ST.LOC OPERAND
Off
XSWI2 ST.LOC OPERAND
MESSAGE
Off
XSWI24 ST.LOC OPERAND
MESSAGE
Off
CLEAR XSWI1 OpCnt:
MESSAGE
No
CLEAR XSWI2 OpCnt:
MESSAGE
No
CLEAR XSWI24 OpCnt:
MESSAGE
No
setting represents the disconnect switch operating counter. As disconnect switches operate by
C30 Controller System
IEC 61850 PROTOCOL
Range: FlexLogic™ operand
Range: FlexLogic™ operand
↓
Range: FlexLogic™ operand
Range: No, Yes
Range: No, Yes
↓
Range: No, Yes
IEC 61850 PROTOCOL
Range: FlexLogic™ operand
Range: FlexLogic™ operand
↓
Range: FlexLogic™ operand
Range: No, Yes
Range: No, Yes
↓
Range: No, Yes
5 SETTINGS
XCBR CONFIGURATION
XSWI CONFIGURATION
GE Multilin