Flexelements™ - GE C30 Instruction Manual

6.3 METERING
6.3METERING
PATH: ACTUAL VALUES
FLEXELEMENT 1
The operating signals for the FlexElements™ are displayed in pu values using the following definitions of the base units.
Table 6–1: FLEXELEMENT™ BASE UNITS
dcmA
RTDs
PATH: ACTUAL VALUES
IEC 61850
GOOSE ANALOGS
The C30 Controller System is provided with optional IEC 61850 communications capability. This feature is
specified as a software option at the time of ordering. Refer to the Ordering section of chapter 2 for addi-
tional details. The IEC 61850 protocol features are not available if CPU type E is ordered.
6
The IEC 61850 GGIO3 analog input data points are displayed in this menu. The GGIO3 analog data values are received
via IEC 61850 GOOSE messages sent from other devices.
PATH: ACTUAL VALUES
DCMA INPUT xx
Actual values for each dcmA input channel that is enabled are displayed with the top line as the programmed channel ID
and the bottom line as the value followed by the programmed units.
PATH: ACTUAL VALUES
RTD INPUT xx
Actual values for each RTD input channel that is enabled are displayed with the top line as the programmed channel ID and
the bottom line as the value.
6-10
METERING FLEXELEMENTS
FLEXELEMENT 1
OpSig: 0.000 pu
BASE = maximum value of the
under the +IN and –IN inputs.
BASE = 100°C
METERING IEC 61850 GOOSE ANALOGS
ANALOG INPUT
0.000
ANALOG INPUT
MESSAGE
0.000
ANALOG INPUT 16
MESSAGE
0.000
METERING TRANSDUCER I/O DCMA INPUTS
DCMA INPUT xx
0.000 mA
METERING TRANSDUCER I/O RTD INPUTS
RTD INPUT xx
-50 °C
C30 Controller System
FLEXELEMENT 1(8)
DCMA INPUT MAX setting for the two transducers configured
6.3.2 IEC 61580 GOOSE ANALOG VALUES
1
2
↓
6.3.3 TRANSDUCER INPUTS/OUTPUTS
DCMA INPUT xx
RTD INPUT xx
6 ACTUAL VALUES
6.3.1 FLEXELEMENTS™
GE Multilin