BrandMotion 9002-7710 Installation Instructions

2014 – Current Mercedes Sprinter Flash Module Interface
Please read thoroughly before starting installation and check that kit contents are complete.
Items Included in the Kit:
Sprinter OBDII flash plug-in
FAKRA to RCA
Sprinter third brake light camera
Chassis harness
4-pin Din to power and video cable
Power harness plug
Foam gasket
Male to male RCA
These instructions
Safety Precautions:
• Work in well ventilated area that is clear of obstructions.
• Secure vehicle with tire chucks in both front and rear of tires.
• Turn vehicle accessories OFF and ensure ignition key is in OFF position.
• Wear safety goggles and snug fitting clothes.
• Use tools only for their intended purpose and which are in good repair.
• Only perform this task if confidence, skill, and physical ability permit.
NOTE: We strive to provide accurate and up-to-date installation instructions. For the latest full color
instructions, as well as an installation video, please visit www.brandmotion.com
9002-7710 v1 10-19-2016.doc
Rear Vision System
(Kit # 9002-7710)
Tools & Supplies Needed:
T-15 Torx screwdriver
Plastic panel removal tool
Wire cutters
Wire strippers
Zip ties
Electrical tape
Page 1 of 2
INSTALLATION INSTRUCTIONS
GS