Advertisement
Dual Mount Universal Kit Aftermarket CMOS Camera with Optional Parking Gridlines
Step 6: Route Camera Harness. Continue routing
harness to the side of the vehicle that supplies power and
then forward.
Step 7: Connect Camera Harness to supplied
Chassis Harness. The optimal location for this junction
may occur at the top of the liftgate or the inner edge of
the trunk depending on vehicle in which installation is in
(Note: most vehicles may already have existing wires
passing through this area; use this route if at all possible).
Step 8: Route Chassis Harness. It may be necessary
to remove sill plates, pillar covers, seat bottoms, side
panels, etc. In some cases even the seatbelt bolts at the
bottom of the pillars must be removed (CAUTION: Any
bolts removed for safety devices must be retightened to
manufacturer's specified torque specifications). Use a
plastic trim removal tool to avoid damage to trim pieces.
9002-7601 Instructions for printing.doc
Installation Instructions (Kit # 9002-7601)
Step 9: Secure Camera Harness to existing vehicle
wiring. This will minimize the chance of binding or
otherwise damaging the harness (Recommended: Wire
Ties or Electrical Tape.)
Step 10: Connect Chassis Harness to supplied
Power Harness.
Step 11: Install aftermarket display/ Navigation
display as per instructions (if required).
Step 12: Connect the male RCA from the Power
Harness to the "Camera IN" on the aftermarket
display/ Navigation display.
Note: Connection to female RCA connector shown.
Page 3 of 5
GS
Advertisement
