Zoom Presets - DigiDesign Control 24 Reference Manual

Using the numeric keypad for Shuttle "lock"
Mode
While in Shuttle mode, you can use the numeric
keypad to control shuttle speed (with "0" being
off, +9 being the fastest forward shuttle and -9
being the fastest reverse shuttle speed). The +/-
keys are used to control shuttle lock direction of
play.
There are two ways to exit Shuttle mode:
Press the SHUTTLE button or any of the Trans-
port buttons.
– or –
Press the spacebar on the computer keyboard,
while pressing ESC/CANCEL on Control 24, or
pressing (CTL)+"." (period).
About Scrub/Shuttle "Lock Out" Behavior
When Scrub or Shuttle is engaged, most other
controls are "locked out." Only the following
Control 24 or Pro Tools controls will be avail-
able for use:
Scrub/Shuttle wheel and buttons
Any TRANSPORT button (disengages
Scrub/Shuttle and reverts Control 24 to normal
transport modes)
Modifier buttons
Channel faders
MUTE and SOLO buttons

Zoom Presets

To recall a Zoom Preset from Control 24:
Press the Zoom Preset's number in the ZOOM
PRESETS section.
Zoom Preset buttons
To store a Zoom Preset from Control 24:
While pressing (CTL), press a Zoom Preset's
number in the ZOOM PRESETS section.
To move the Edit Cursor and Edit Selection to
Adjacent Tracks:
The UP/DOWN buttons will move the Edit
cursor to the next or previous track, and can also
be used to move or extend Edit selections to the
next or previous track.
To move the Edit cursor or an Edit selection to the
previous or next track:
Press the NAV or SEL/ADJ buttons.
1
Press UP or DOWN to move the cursor or se-
2
lection to the previous or next track.
To extend an Edit selection to the previous or next
track:
Press the NAV or SEL/ADJ buttons.
1
While pressing SHIFT/ADD, press UP or
2
DOWN to extend the selection to the previous
or next track.
Chapter 9: Navigation and Editing 81