Automating Plug-In Flip Mode - DigiDesign Control 24 Reference Manual

Rotate the channel encoder to write automa-
5
tion moves. Following all Pro Tools settings for
touch time-out and thinning, automation will
be recorded to the plug-in automation playlist.
You can punch-out of automation recording
6
at any time by pressing the appropriate AUTO-
MATION ENABLE switch.
If you want to add additional automation
moves or augment your previous pass, fol-
low the previous procedure but select Auto
Touch or Auto Latch modes. These enable
you to add new automation only when you
actually move an encoder knob.

Automating Plug-In Flip Mode

To enable plug-in automation in Plug-In Flip mode:
Make sure the plug-in's track is in an automa-
1
tion writing mode (Write, Touch, or Latch, or a
Trim mode).
Make sure that plug-in automation recording
2
is enabled (the PLUG-IN button should be flash-
ing in the ENABLE column of the master AUTO-
MATION section).
Press a channel AUTO button, corresponding
3
to the plug-in parameter you want to automate.
When a parameter is armed for automation, the
AUTO LED flashes. When a write pass is under-
way, the AUTO LED remains lit.
If the automation mode is TOUCH, after the
fader is released and the touch timeout period is
reached, the fader will return to the previous
value or automation and the AUTO LED will be-
gin to flash again, indicating that the touch pass
is over.
128 Control 24 Reference Guide