Frequency Generator - Freq. Gen - d&b audiotechnik 10D Manual

d&b 10D/30D Manual 1.10 en

13.10. Frequency generator - Freq. gen.

Selecting «Freq. gen.» opens the corresponding subscreen.
Each amplifier channel is equipped with an independent signal
generator offering sine wave or pink noise signals.
The generator provides pure-spectral sine wave signals with high
frequency accuracy and free of harmonics.
The generator can be used to check the connected loudspeakers
or to identify room resonances, for example.
The generator is inserted in the signal path after the input section
and before the actual signal processing. The test tone will sum up
with any input signal present.
Note: As a precautionary measure, the frequency generator
is always set to Off after the device is powered on.
Off The frequency generator is switched off
(Bypass).
Sine/ To turn the frequency generator on, select
either «Sine» or «Pink noise», depending on
Pink noise
the desired signal.
Frequency The frequency is adjustable from 10 Hz to
20 kHz.
On the top right of the «Frequency/FRQ» input
field, the increment is displayed as an octave
value. When you click the field for the first
time, the frequency increment is set to 1/6
octave. When you click the field again, you
can toggle between 1/6 and 1/96 octave
increments.
To confirm the set frequency, click the input
field again.
Level
The level in dBu is adjustable from –57.5 dB
to +6 dB in 0.5 dB steps.
The level value corresponds to the level at the
controller signal input. The actual output
voltage depends on the channel input gain,
the frequency dependent gain of the selected
loudspeaker setup and the EQ settings, if
applicable.
On the Home screen, the On/Off status of the generator is
indicated by the entry «FG» on the Channel view button of the
corresponding channel strip, as shown in the graphic opposite.
75