d&b audiotechnik 10D Manual page 43

Fallback settings example
A1/A2 Regular, A3/A4 Fallback.
Fallback inputs are active.
d&b 10D/30D Manual 1.10 en
Selecting «Fallback» from the «Input settings» menu opens the
corresponding subscreen.
Off
Disables the function.
The On/Off status is also displayed on the
«Input settings» screen.
Manual
The desired signal path («Source») can be selected
manually, either locally or via the Web Remote
interface or via the d&b Remote network using R1.
Auto
To enable the automatic switch, Input monitoring
(«Mon») must be activated and correspondingly
parameterized.
The desired signal path («Source») can be selected
manually, either locally or via the Web Remote
interface or via the d&b Remote network using R1.
After the Fallback function has been triggered, it can
be reset manually by reactivating (selecting) the
«Regular 1/2» input source.
This can be done either locally or via the Web
Remote interface or via the d&b Remote network
using R1.
When the Fallback function is activated, the Input routing screen is
divided into two groups, «Regular» and «Fallback».
Regular inputs are always input pair 1/2, Fallback inputs are
always input pair 3/4.
The white cross indicates which of the groups is currently active (as
shown in the graphic opposite).
Note: Any input selected as Fallback input is disabled in the
Input routing menu.
The Input routing settings are stored when the device switches
to Fallback mode. When the Fallback mode is deactivated
(either manually or automatically), the last Input routing
settings defined are restored.
Fallback (FB) and detection modes
Input fallback automatically switches from the selected input source
to another (Fallback) input source when either a digital (AES) sync
signal (Lock) or a pilot signal (Pilot) or both of them are missing.
43