d&b audiotechnik 10D Manual page 23

d&b 10D/30D Manual 1.10 en
Edit dialog
To change the value of an input field such as Level, Delay time,
CPL, EQ settings or Speaker setup, proceed as follows:
1. Enter the desired value or select the respective item.
↳ For parameters such as «Speaker setup» or «Filter type» a
drop-down list is provided to allow easy and quick access
to the list items.
You can simply scroll through the list or type the
corresponding character directly into the input field.
2. Confirm your entry by clicking «OK».
↳ The entered value or selected list item will be applied and
the «Edit» dialog will be closed.
Note: However, please note that you have to finally confirm
your settings by clicking the respective «OK» button or input
field again (Edit cursor changes from yellow to white Þ
Position cursor).
Additional editing
Value +/ To change the value of an input field such as CPL,
Value – Level, Delay time, EQ settings or Speaker setup
using the «Value +»
«Value –» buttons, proceed as follows:
1. Select the appropriate field and change the
value using the «Value +»/«Value –» buttons.
↳ Every mouse click will increment the
«Value +»/«Value –» by 0.5.
For example, to increase the level by 3 dB,
simply click the «Value +» button six times
or simply hold the mouse button until the
amount of steps has been reached.
On the left, a blue counter box will appear
showing the number of steps.
2. When the desired value (steps) has been
reached, stop clicking or release the mouse
button respectively.
↳ The counter box moves to the input field
previously selected.
3. As an alternative, values can also be adjusted
using the wheel mouse.
↳ Simply select the appropriate field and
adjust the value using the wheel. This is very
useful when entering major changes.
The counter field will also appear and
behaves in the same manner as described
above.
4. To confirm the set value, click the relevant field
again or click the respective «OK» button.
23