d&b audiotechnik 10D Manual page 71

d&b 10D/30D Manual 1.10 en
Speaker
The bottom left of the «Speaker» input field
displays the version of the selected loudspeaker
setup while the bottom right displays the actual
setup name.
The loudspeaker list is either in numerical or
alphabetical order depending on the selected
series.
When «(All)» is selected in the «Series» field, the
list starts with the numeric setup names followed
by the remaining setup names in alphabetical
order. The starting point, however, is the setup
currently loaded.
OK Selecting «OK» adjacent to the «Speaker»
selection field confirms the configuration and the
selected setup will be activated.
Clear... To prevent accidental reset when you click the
«Clear...» button, a dialog will pop up prompting
you to confirm the reset or cancel the sequence
by clicking the Back button ( ).
Selecting the «Clear...» button clears/resets the
following loudspeaker related settings of the
respective channel.
▪ Configuration switches (Filter_1, Filter_2,
Filter_3) are reset.
▪ Level is set to 0 dB.
▪ Delay settings are reset (the selected unit will
be kept).
▪ All EQ settings are disabled.
Array
For applicable loudspeakers, the
Processing «ArrayProcessing» button becomes functional. It
indicates the On/Off status of the function and
provides direct access to the ArrayProcessing
subscreen, which is described in
Þ Chapter 13.8.1. "ArrayProcessing"
on page 72.
Note: ArrayProcessing does not apply to
all loudspeakers. When the function is not
applicable, this button is not functional.
LoadMatch
For applicable loudspeakers, the «LoadMatch»
button becomes functional. It Indicates the
On/Off status of the function and provides direct
access to the LoadMatch subscreen which is
described in Þ Chapter 13.8.2. "LoadMatch"
on page 73.
Note: LoadMatch does not apply to all
loudspeakers. When the function is not
applicable, this button is not functional.
71