Source Audio Ventris Dual Reverb User Manual page 40

Follow these steps for configuration:
1. Press the C
ONTROL
red.
2. Press and hold the C
(approximately one blink per second).
3. Tap the external switch once.
4. Click the O
N
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knobs and Neuro parameters (Neuro parameters are only accessible when
connected to the Neuro Mobile App or Neuro Desktop Editor) you wish to control with the
expression pedal to the minimum desired position and then click the O
The C
ONTROL
control one or more knobs with the expression pedal, up to six total knobs.
6. Move the knobs and Neuro parameters you wish to control with the expression pedal to the
maximum desired position and then click the O
be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
External Switch as Expression Toggle (1/8" (3.5mm) TRRS Connection – CONTROL INPUT
Jack)
To use this mode, connect an external switch to C
S position instead of the E
WITCH
Follow these steps for configuration:
SA262
Gr ound
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
/O F once. The C
FF OOTSWITCH
L will now blink even faster (about 4 blinks per second). Note that you may
ED
position. The following plug configuration is required:
XP
Gr ound Switch Out
Ventris Dual Reverb Owner's Manual
Power (Switch pul l -up)
1/ 4"
Switch Out
until the C
ONTROL
L will blink faster (about 2 blinks per
ONTROL ED
/O F
N FF OOTSWITCH
I and set the P
ONTROL NPUT
1/ 8" (3.5mm)
Power (Switch pul l -up)
L should be lit
ONTROL ED
L begins to blink slowly
ED
/O F
N FF OOTSWITCH
. The C L
ONTROL ED
I S to the
EDAL N WITCH
.
will now
40