Source Audio Ventris Dual Reverb User Manual page 41

1. Press the C
ONTROL
red.
2. Press and hold the C
(approximately one blink per second).
3. Tap the external switch once.
4. Click the O /O
N
second). Now, it is time to map the external switch to the effect parameters.
5. Move the knobs and Neuro parameters (Neuro parameters are only accessible when
connected to the Neuro Mobile App or Neuro Desktop Editor) you wish to control with the
expression pedal to the minimum desired position and then click the O
The C
ONTROL
control one or more knobs with the expression pedal, up to six total knobs.
6. Move the knobs and Neuro parameters you wish to control with the expression pedal to the
maximum desired position and then click the O
be lit solid red.
7. After setting the minimum and maximum knob positions, the parameter mapping is
complete.
Hot Hand Input
The Hot Hand 3 Wireless Effects Controller can be connected directly to the C
wireless motion control of the Ventris Reverb's effect parameters. The Hot Hand has two axes of
expression: X and Y. These signals are carried on the two rings of the TRRS cable that comes from the
Hot Hand receiver. The Ventris uses the X expression signal.
Configuring the Hot Hand
When the Hot Hand is connected to the Ventris, follow these simple steps to calibrate it and map it
to control different effect parameters.
1. Press the C
ONTROL
2. Press and hold the C
(approximately one blink per second).
3. Move the Hot Hand ring over the range of motion you would like to use to control the
Ventris. The easiest way to do this is to move the ring in the same way that you intend to
move it as you perform. The Ventris will intelligently select the X or Y axis of the Hot Hand
automatically, based on the motion of the ring.
SA262
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
F once. The C
FF OOTSWITCH
L will now blink even faster (about 4 blinks per second). Note that you may
ED
Gr ound
Y Exp
I B to enable external control. The C
NPUT UTTON
I B
ONTROL NPUT UTTON
Ventris Dual Reverb Owner's Manual
until the C L begins to blink slowly
ONTROL ED
L will blink faster (about 2 blinks per
ONTROL ED
/O F
N FF OOTSWITCH
Power
X Exp
until the C L begins to blink slowly
ONTROL ED
L should be lit
ONTROL ED
/O F
N FF OOTSWITCH
. The C L will now
ONTROL ED
I jack for
ONTROL NPUT
L should be lit red.
ONTROL ED
.
41