Table 2: Levelmaster Parts List; Table 3: Levelmaster Optional Parts List - ABB LevelMaster 7100 User Manual

Table 2 describes the LevelMaster parts list. The list is for the convenience of those who receive the LevelMaster in a kit form.
Some parts may be connected to, or already installed in, other individual parts, but should be accounted for before starting the
installation.
IMPORTANT NOTE: Components and replacement kits with other part numbers may be available. Contact ABB
for additional details or if the list provided does not meet the site requirements.
Qty Part name
1 Sensor assembly
1 Electronic enclosure
1 Top cap
1 Nipple
1
or Float
2
1 Electronic headboard
Optional parts list
Table 3 describes optional parts used in LevelMaster installations.
Qty Part name
1 Installation clamps
1 Tank port bushing
1 Cord connector

Table 2: LevelMaster parts list

Description
Sensor coil assembly
Shipped inside of the casing. It has the same
length as the casing.
It has a ribbon cable coming out one end
terminated with a 16-pin connector.
Approximately 3 ½ inch diameter x 6 inch
long with a screw-on cover
Aluminum bushing that screws on to the top
of the casing, leaving a ¾ inch NPT threaded
female opening
¾ inch pipe nipple located between the top
cap bushing and the electronics enclosure
1, 2, or 3 inch diameter
Approximately 2 ½ inch x 4 inch. It may be
shipped inside the electronics enclosure.

Table 3: LevelMaster optional parts list

Description Part number
Aid in the assembly and
installation of LevelMasters 1801393-001
received as a kit
3 inch NPT male x 2 inch
NPT female reducer
bushing or 4 inch NPT
1291003-023 (3 inch)
male x 2 inch NPT female
1291003-024 (4 inch)
reducer bushing,
depending on the tank port
opening size
2 inch NPT male cord
1291026-008
connector that screws into
the tank port bushing
Part number Notes
Number is
different for The sensor assembly must remain
each sensor inside the casing to avoid damage
to the coil.
length
supported.
None Houses the electronics board
None
None
Float types: passive or active
Number is
(inlcuding batteryless)
different for
Liquid type: Oil or water
each type of
Two floats are required for an oil
float
and water application.
Batteryless float kit requires board
with part number 2104836-001.
Oil level float part number
2018392-017
2103766-006
Water level float part number
2103766-007
Firmware version 7.0
Required for batteryless floats
2104836-001
Supports all existing types
Legacy part is available while
2018546-005
supplies last.
Notes
Mounting kit to secure unit to the tank
LevelMaster 7100 User manual 2105835 Rev AA | 13