Activating The Tank Level Pass-Through - ABB LevelMaster 7100 User Manual

Command
syntax
U**T
U**ED
U**EE
U**EH
U**ERaaaE
Wddd
U**F
U**N
U**OL
U**OW
U**OF
U**OV
U**PS
U**V
U**S
UxxPxxxxxx
UxxCxxxxxx
U**GS
U**GR
U**GAxxx
A.2

Activating the tank level pass-through

To use terminal mode for tank level pass-through:
1. Connect the PC running PCCU32 to the flow computer with either an MMI cable (RS-232), a USB cable or an Ethernet
cable.
2. Start PCCU.
3. Click Entry on the toolbar.
4. Click Communications on the navigation tree.
5. Set the Unkey Delay to 1.
6. Click Send.
7. Click Terminal on the toolbar.
8. To activate Tank Level Pass Through:
a. Type "TLPT 1" (Tank Level Pass Through Activate), at the prompt -> for XSeries FCUs and XRCs.
=
b. Type "TLPT=0" (Tank Level Pass Through Activate), at the prompt -> for 64XX and 67XX FCUs.
9. Wait for the prompt LM> to appear to issue commands. The prompt indicates that the LevelMaster protocol is now in use.
a. For LevelMasters with boards whose firmware version is 5.015-5.018, use the commands listed in Table 12.
For LevelMasters with boards whose firmware version is 7.000, use the commands listed in
b. Table 13.
10. Press Enter on the keyboard after the command has been typed.
Description
Measure displacement in new test mode
EEPROM dump in DEC 16x16 format
EEPROM dump in DEC 8x32 format
EEPROM dump in HEX 8x32 format
Write to memory aaa data to ddd
Read/write mode number
Read/write unit number
Oil level offset
Water level offset
Temperature reading offset
Voltage reading offset
Phase shift test
Return software version
Return settings
Enter password
Change password
Gain set
Gain read
Gain all set
LevelMaster 7100 User manual 2105835 Rev AA | 87