10. Tighten using the lower part of the body (Figure 17).
11. Tighten the nut of the cord connector to form a rain-tight seal around the casing.
12. Plumb the conduit or cable for the wiring into the ¾ inch hub on the side of the electronics enclosure:
a.
For division 1 and 2 hazardous areas, use a conduit.
b.
For general-purpose areas, a cable with a cord connector can be used.
13. Proceed to section 4, Wiring.
Figure 17: Nut and body installation
LevelMaster 7100 User manual 2105835 Rev AA | 21