Figure 6: Levelmaster Components In Typical Installation - ABB LevelMaster 7100 User Manual

2. Carefully unpack and remove the items from each carton and inspect for damage:
a. The exterior of the individual components for dents, chipped paint, etc.
b. The sensor wiring harness for damage or breakage
3. Open the electronics enclosure by removing its cover.
a. Visually inspect the electronics board and cables for damage.
4. Compare the packing list with the materials received. Check for missing or incorrect parts.
5. To report any discrepancies, call the ABB office listed under Contact us on the back cover of this manual.
IMPORTANT NOTE: Do not return equipment to ABB without prior written consent. Returns are subject to the
terms and conditions specified by ABB.
Damaged components
If any components have been damaged or if there are noticeable defects, notify an ABB representative. Keep all shipping
materials for the carrier's inspection. ABB will arrange for immediate repair or replacement; see the Contact us section located
on the last page of this manual.
Parts list
Figure 6 depicts each component of the fully assembled LevelMaster as required for installation. The figure shows a typical oil
and water application that requires two floats. Some applications will measure only one medium and will use only one float. Use
this figure as a reference to identify the required parts.
ELECTRONICS ENCLOSURE
¾" CONDUIT ENTRANCE
TAG BRACKET
NAME TAG
CASING
TANK PORT BUSHING
TANK HEIGHT
LevelMaster 7100 User manual 2105835 Rev AA | 12
TANK

Figure 6: LevelMaster components in typical installation

ELECTRONIC BOARD
¾" NPT MALE NIPPLE
LOCK NUT
TOP CAP BUSHING
CORD CONNECTOR
SENSOR ASSEMBLY
OIL FLOAT
WATER FLOAT
FLOAT CLAMP