Chapter 3. Using Keypads And Keyboxes; Checking Out Keypads - Supra KeyAdvantage User Manual

Chapter 3. Using KeyPads and KeyBoxes

This chapter provides information on using KeyPads and KeyBoxes, including checking modules in and out, as
well as reading, modifying, and diagnosing the modules.

Checking Out KeyPads

To activate the KeyPad and program the key holder's PIN code, access hours, and KeyBox access permissions,
you need to check out the KeyPad.
To check out a KeyPad, do the following:
1. Click KeyPad > Check Out. The KeyPad Check Out window displays, as shown in Figure 19.
Figure 19. KeyPad check out window
2. Enter your login ID and PIN code.
3. Click Check Out. The KeyPad Check Out window displays, as shown in Figure 20.
Figure 20. KeyPad check out confirmation
4. Place the KeyPad upside down on the programming base.
5. Once the yellow IR light on the programming base is lit, press the green Start (
KeyPad.
6. Click Close.
If you attempt to check out a KeyPad after you have exceeded the maximum number of KeyBox accesses, a
warning message will appear that reads:
The maximum number of KeyBox accesses has been reached.
Chapter 3
Using KeyPads and KeyBoxes
) button on the
46