Browsing Alarms; Entering The Password - ComAp INTELICOMPACT-NT Operator's Manual

2.7 Browsing alarms

The Alarmlist and ECU Alarmlist are displayed on the last two screens in the measurement page. If
the main screen is displayed then the Alarmlist screen will appear automatically always when a new
alarm occurs. It can be also displayed manually as described in the chapter "View measured values"
in Reference Guide.
•
Use the to move over the alarms in the ECU Alarmlist. Details of the selected alarm are
displayed in the bottom line.
•
Press button to reset alarms.
•
Active alarms are displayed as white text on black background. It means the alarm is stil
active, i.e. the appropriate alarm conditions are still present.
•
Inactive alarms are displayed as black text on white background. It means the alarm is no
more active, i.e. the appropriate alarm conditions are gone.
•
Not confirmed alarms are displayed with an asterisk. It means the alarm is still not
acknowledged (confirmed).
A L
LARM IST
ECU A L
LARM IST
N :
OTE
The ECU AlarmList is visible only if an ECU is configured.

2.8 Entering the password

The password must be entered prior adjusting setpoints that are password-protected. Password is
located in the first group of setpoints and the way how to enter or change password is similar to
change of setpoints as described in the "Setpoints" chapter in
N :
OTE
It is possible to change only passwords of the same or lower level than actually entered password!
I C -NT, SW
NTELI OMPACT
1.3, ©C A – S
VERSION OM P
Reference Guide.
2011 R
EPTEMBER EFERENCE
G . 10
UIDE PDF