Raymarine C Series Reference Manual page 86

72
4. Select waypoint to be added:
Add new waypoint at cursor
Use existing waypoint
5. If required, you can add further waypoints to the end of the route by repeating
steps (3) and (4) above.
If you wish to add a combination of existing and new waypoints to the end of a
Note:
route, you will need to move control from/to the on-screen cursor/Make Route screen
(see page 62).
Move a waypoint within a route
Move cursor over
waypoint to be
repositioned
A waypoint's new position will be reflected in all other routes that make use of
Note:
it.
Remove a waypoint from within a route
You can remove a waypoint from within a route provided that it has not been used in
another route. If you try to remove a waypoint that is used in another route, the system
will warn you that it cannot be removed.
PLACE WAYPOINT
USE WAYPOINT
LIST...
MOVE WAYPOINT
WPT
WPT
Move cursor over
waypoint to be removed
C-Series Display Reference Manual
3
1
2
New leg added to end of route.
Or:
Make Route
Waypoints Sunday tour
Harbour Ent. 01 Midchannel
Midchannel 02 Outer Harbour
Outer Harbour 03 Harbour Ent.
Pierhead
Waypoint 4
0 0
50 16'.75N 50 47'.356N
0 0
001 6'.095W 001 6'.604W
New leg added to end of route.
WPT
Drag cursor to
new position
REMOVE
WAYPOINT
RTE
OK