Advertisement
7PZ IP
Protective Valve
7PZ IP
Set Up
Power Supply:
The ADJ 7PZ IP contains an automatic voltage
switch, which will auto sense the voltage when it is plugged into the
power source. With this switch there is no need to worry about the cor-
rect power voltage, this unit can be plugged in anywhere.
DMX-512:
DMX is short for Digital Multiplex. This is a universal pro-
tocol used as a form of communication between intelligent fixtures
and controllers. A DMX controller sends DMX data instructions from
the controller to the fixture. DMX data is sent as serial data that trav-
els from fixture to fixture via the DATA "IN" and DATA "OUT" XLR ter-
minals located on all DMX fixtures (most controllers only have a DATA
"OUT" terminal).
DMX Linking: DMX is a language allowing all makes and models of
different manufactures to be linked together and operate from a single
controller, as long as all fixtures and the controller are DMX compli-
ant. To ensure proper DMX data transmission, when using several
DMX fixtures try to use the shortest cable path possible. The order
in which fixtures are connected in a DMX line does not influence the
DMX addressing. For example; a fixture assigned a DMX address of 1
may be placed anywhere in a DMX line, at the beginning, at the end,
or anywhere in the middle. When a fixture is assigned a DMX address
of 1, the DMX controller knows to send DATA assigned to address 1
to that unit, no matter where it is located in the DMX chain.
DMX Cable Requirements:
The 7PZ IP can be controlled via DMX-
512 protocol. The 7PZ IP has 12 DMX channel modes, please see pages
9-21 for the different modes. The DMX address is set on the back panel
of the 7PZ IP.
Cable Requirements: This fixture powered by powerCON TRUE1 power
cables. These cables are specifically designed to maintain the integrity
of the IP rating. When using this fixture outdoors be sure to ONLY use
the ADJ cables that have been manufactured to meet the IP rating.
"First" DMX Cables - Special DMX "First" cable may be purchased
from ADJ to provide a means of data communication with standard DMX
fixtures for indoor use. These cables will come with the IP rated connec-
tor on one end and either a 3-pin XLR male or female connector on the
other depending on model. Be sure to only use these cables for inter-
grading this fixture in a standard DMX chain.
ADJ Products, LLC - www.adj.com - 7PZ IP User Manual Page 7
ADJ Products, LLC - www.adj.com - 7PZ IP User Manual Page 6
Advertisement
