Products, LLC brands and product names are trademarks or registered trademarks of their respective companies. ADJ Products, LLC and all affiliated companies hereby disclaim any and all liabilities for property, equipment, building, and electrical damages, injuries to any persons, and direct or indirect economic...
Page 3
General Information UNPACKING Thank you for purchasing the 7PZ IP by ADJ Products, LLC. Every 7PZ IP has been thoroughly tested and has been shipped in perfect operating condition. Carefully check the shipping carton for damage that may have occurred during shipping. If the carton appears to be damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate the unit has arrived intact.
D. The appliance does not appear to operate normally or exhibits a m arked change in performance. ESD CAUTION: This unit, like any wireless electronic device is highly susceptible to ESD, electrostatic discharge. ESD can severely damage the unit. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 4...
Page 5
(available at most electrical suppliers) to prevent water ingress/condensation and/or corrosion. COATING Optional Corrosion-Resistant OPTIONAL CORROSION - RESISTANT Coatings may be available for this fixture. Please consult your ADJ Products, LLC sales representative for details. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual...
Page 6
7PZ IP Protective Vent ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 6...
Page 7
7PZ IP Set Up Power Supply: The ADJ 7PZ IP contains an automatic voltage switch, which will auto sense the voltage when it is plugged into the power source. With this switch there is no need to worry about the correct power voltage, this unit can be plugged in anywhere. ...
Page 8
XLR connector of the last unit in your daisy chain to terminate the line. Using a cable terminator (ADJ part number Z-DMX/T) will decrease the possibilities of erratic behavior. Termination reduces signal errors and avoids signal transmission problems and interference.
Page 12
DIMMER CURVES: 0 - 20 STANDARD 21 - 40 STAGE 41 - 60 61 - 80 ARCHITECTURAL 81 - 100 THEATRE DEFAULT TO UNIT CURVE SETTING 101-255 ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 12...
Page 13
DIMMER CURVES: 0 - 20 STANDARD 21 - 40 STAGE 41 - 60 61 - 80 ARCHITECTURAL 81 - 100 THEATRE DEFAULT TO UNIT CURVE SETTING 101-255 ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 13...
Page 14
DIMMER CURVES: 0 - 20 STANDARD 21 - 40 STAGE 41 - 60 61 - 80 ARCHITECTURAL 81 - 100 THEATRE DEFAULT TO UNIT CURVE SETTING 101-255 ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 14...
Page 15
Operating through a DMX controller gives the user the freedom to create their own programs tailored to their needs. This function also allows the fixtures to be used as spotlights. The 7PZ IP has 12 DMX modes. 1. This function will allow you to control each individual fixture’s traits with a standard DMX 512 controller.
Page 16
4. When you have found your desired color change speed press ENTER. Your are now in the strobe menu. You can use the UP or DOWN buttons to adjust the strobe rate. Press ENTER when have finished making your adjustments. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 16...
Page 17
DOWN buttons to make adjustments. Press the ENTER button to scroll between the 3 menus. 3. When you are finished making your adjustment press ENTER and press the MODE button to exit this menu. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 17...
Page 18
3. Press the UP or DOWN buttons, until “TimeInfo LastClea” is displayed, and press ENTER. 4. The the last time the current running time was cleared will now be displayed, press MODE to exit. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 18...
Page 19
ZoomRset” is highlighted, then press ENTER. 2. Press the UP or DOWN buttons, until “ZoomRset Calibrat” is displayed, and press ENTER. 3. The display will now show the current calibration setting. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 19...
Page 20
4. On the “Secondary” units press the MODE button until “Menu Secondry” is displayed and press ENTER. The unit is now set as the “Secondary” unit. Each secondary unit must be set to the same setting. ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 20...
Page 21
3. After you have set the WiFly address, follow the DMX instructions on pages 15-16 to select your desired DMX Channel mode and set your DMX address. 4. Apply power to the ADJ WiFly Transceiver. The fixture must be set up first before you apply power to WiFly Transceiver.
3. Always be sure to dry all parts completely before plugging the unit back in. Cleaning frequency depends on the environment in which the fixture operates (i.e. smoke, fog residue, dust, dew). ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 27...
All shipping charges must be pre-paid. If the requested repairs or service (including parts replacement) are within the terms of this warranty, ADJ Products, LLC will pay return shipping charges only to a designated point within the United States. If the entire instrument is sent, it must be shipped in its original package. No accessories should be shipped with the product.
Dimensions (LxWxH): 10.5” x 13.75” x 15” / 270 x 350 x 380mm • • Weight: 25 lbs / 11 kg. • Metal Black Housing • IP 65 What’s Included • Power Cable (1M) • Manual ADJ Products, LLC - www.adj.com - 7ZP IP - User Manual Page 29...
Page 30
ADJ Products, LLC Follow Us on: 6122 S. Eastern Ave. Los Angeles, CA 90040 USA Tel: 323-582-2650 / Fax: 323-725-6100 Web: www.adj.com / E-mail: info@americandj.com A.D.J. Supply Europe B.V. Junostraat 2 6468 EW Kerkrade facebook.com/americandj Netherlands twitter.com/americandj service@adjgroup.eu / www.adj.eu Tel: +31 45 546 85 00 / Fax: +31 45 546 85 99 youtube.com/adjlighting...
Need help?
Do you have a question about the 7PZ IP and is the answer not in the manual?
Questions and answers