Advertisement
7PZ IP
"First" Power Cable – A special power "First" cable is included with
every fixture. This cable is used to provide power to your fixture. This
cable comes with the IP rated twist lock connector on one end and a
standard Edison 3-prong, grounded prong on the other end. Be sure to
only use this cable for power distribution and never attempt to connect
this cable to the DMX lines.
You can chain multiple fixtures together through serial linking. Using the
IP rated signal cables provided through ADJ (part# TRU113). Always
REMOTE
INPUT
OUTPUT
CONTROL
INPUT
be sure to daisy-chain your in and out data connections, never split
or "Y" your DMX connections unless you are using an approved DMX
splitter such as the ADJ WiFly D6 Branch or the original D6 Branch
(Both not IP rated).
POWER
Special Note: Line Termination.
used, you may need to use a terminator on the last unit to avoid erratic
behavior. A terminator is a 110-120 ohm 1/4 watt resistor which is con-
nected between pins 2 and 3 of a male XLR connector (DATA + and
DATA -). This unit is inserted in the female XLR connector of the last
unit in your daisy chain to terminate the line. Using a cable terminator
(ADJ part number Z-DMX/T) will decrease the possibilities of erratic
behavior.
Termination reduces signal errors and
avoids signal transmission problems
1
1
DMX512 IN
and interference. It is always advisable
3
3-PIN XLR
2
2
to connect a DMX terminal, (Resistance
120 Ohm 1/4 W) between PIN 2 (DMX-)
and PIN 3 (DMX +) of the last fixture.
5-Pin XLR DMX Connectors.
512 data cables for DATA transmission in place of 3-pin. 5-pin DMX
fixtures may be implemented in a 3-pin DMX line. When inserting stan-
dard 5-pin data cables in to a 3-pin line a cable adaptor must be used,
these adaptors are readily available at most electric stores. The chart
below details a proper cable conversion.
3-Pin XLR to 5-Pin XLR Conversion
Conductor
Ground/Shield
Data Compliment (- signal)
Data True (+ signal)
Not Used
Not Used
ADJ Products, LLC - www.adj.com - 7PZ IP User Manual Page 8
REMOTE
INPUT
OUTPUT
SOUND
CONTROL
INPUT
When longer runs of cable are
Some manufactures use 5-pin DMX-
3-Pin XLR Female (Out)
5-Pin XLR Male (In)
Pin 1
Pin 1
Pin 2
Pin 2
Pin 3
Pin 3
Do Not Use
Do Not Use
Set Up
7PZ IP
Channel
1
2
3
4
7PZ IP
Channel
1
POWER
2
3
4
5
Value
0 - 255
0 - 255
0 - 255
0 - 255
NARROW - WIDE
Value
0 - 255
0 - 255
0 - 255
0 - 255
0 - 255
NARROW - WIDE
ADJ Products, LLC - www.adj.com - 7PZ IP User Manual Page 9
4 Channel - HSI
Function
HUE
0% - 100%
SATURATION
0% - 100%
INTENSITY
0% - 100%
ZOOM
5 Channel - RGBW
Function
RED
0% - 100%
GREEN
0% - 100%
BLUE
0% - 100%
WHITE
0% - 100%
ZOOM
Advertisement
