Table of Contents
Advertisement
5. Install the end plate to the top of the track
with the four (4) self-cutting Torx screws using
the supplied T30 Torx bit. Making sure not to
pinch the wires on the pigtail .
NOTICE
Too much torque applied to these screws may result
in damage. Take your time and apply grease to
threads.
6. Install one of the rack pre-compression screws
in the threaded hole in the top plate of the
rail, and tighten it as firmly as possible by
hand with a 5/32" Allen wrench. Make sure to
use the 1 1/4" pre-compression screw.
See Figure 4-22.
Figure 4-22
7. Plug in the power supply at either end of the
rail, depending on the closest or most
convenient location of a wall power supply.
Minimize wire length and intrusion.
WARNING
!
Use care in routing the charger lead. If possible,
secure along or inside wall to avoid the creation of
a tripping hazard.
PINNACLE HD STAIR LIFT: SECTION 4
FOOTREST AND SEAT
INSTALLATION
1. Remove the footrest from the box and use the
installation switch to drive the chassis
downward to a position about 6" clear off the
floor. This will provide a safe area to install
and adjust the footrest. Do not drive the unit
into bottom stop. See Figure 4-23.
Figure 4-23
2. Turn the red "On/Off" switch located on the
top of the chassis to the "Off" position.
3. Position the footrest onto the two (2) seat-
leveling bolts on the outside of the chassis by
aligning the large opening at the slot ends of
the footrest. See Figure 4-24.
Figure 4-24
4. Ensure that the footrest is fully engaged.
5. Position the rear seat support onto the two (2)
seat-leveling bolts on the backside of the chassis
by aligning the large opening at the slot ends of
the footrest. See Figure 4-25.
SL600HD PINNACLE STAIR LIFT:
INSTALLATION
Install Manual
13
25MAR2022 | 75403 E
Advertisement
Table of Contents
