Twice-Yearly Maintenance Operations; Carrying Out The Monthly Maintenance Procedure; Checking The Working Conditions; Checking The Wiring And Connections - Technogym Run MED Service Maintenance Manual

10.4.

TWICE-YEARLY MAINTENANCE OPERATIONS

These operations can only be carried out by a qualified technician specifically trained by
Technogym and authorized to carry out machine installation and adjustments, as well as
special maintenance operations or repairs which require special knowledge of the
machine, its operation, safety systems and working procedures.
The six-monthly maintenance operations involve checking the functioning, wear and tension of the
m echanical components so as to ensure the correct and safe operation of the machine.
For the six-monthly maintenance of the machine, proceed as follows:
10.4.1.

CARRYING OUT THE MONTHLY MAINTENANCE PROCEDURE

1. Carry out the procedure described in paragraph 10.3. "Monthly maintenance operations".
10.4.2. C
HECKING THE WORKING CONDITIONS
1. Check that the machine is connected directly to the wall outlet, without any extension cords,
and that the outlet is correctly earthed.
2. Using a multimeter, check that the machine earth node is correctly connected to earth.
10.4.3. C
HECKING THE WIR
1. Open all the machine guards.
2. Check the condition of all the cables:
• External conditions;
• Possible rusting of the connectors;
• Electrical continuity of the individual wires;
• Isolation of the individual wires toward ground.
Repair and/or replace any non-conforming wires.
3. Check the condition of the fuses using a tester.
10.4.4. C
HECKING THE WEAR AND LUBRICATION OF THE TREAD BELT AND
RUNNING DECK
1. Disassemble the rear and driving rollers, the running deck and the tread belt.
2. Check the state of wear of both the running deck and the tread belt. Replace if there are evident
signs of wear.
3. Using a clean cloth, wipe the entire surface of the running deck and the underside of the tread
belt.
4. Then lubricate the running deck and tread belt over its entire length using spray Silube oil.
5. After reassembling the machine, start walking on it at a speed of approximately 3 km/h, being
careful to tread on the full width of the belt so as to distribute the oil over its entire surface.
Page 10.4
RUN MED: Service & Maintenance Manual - rev. 1.0
ING AND CONNECTIONS